LED Rigid Bar For Dynamic Lightbox

Features
This LED rigid bar is used for dynamic lightbox.

Every LED can be lighten on or off by software so that the whole strips can show letters, pictures and movies.

Specification:

●0.5W 3030SMD white LED.
●120degree viewing angle.
●Working voltage is DC12V.
●parallel connection, easy installation.
●Aluminum PCB, better heat dissipation.
●Every 3 LEDs can be cut as one unit.
●Different length is available

●Absolute Maximum Ratings

Light box installation flow
1. Client provide light box size and picture size, movie.
2. Confirm spacing and quantity of strips.position of LEDs are on the right place with key picture points.
3. Make a flash, according to the layout and quantity of LEDs.
4. Open software, set up program, make connection draft, upload flash, then come out a file, copy the file into SD card. (Please check controller software specification for details)
5. Connect power supply and controller, power on to test. (Note that the signal cable is not hot-pluggable)

Notes
1. If the quantity of strips connection is more than prescriptive quantity, the wire decay will lead to the drop of voltage, over loading will lead to safety misadventure.
2. The right power supply should be calculated when connect the whole light box , and the wire diameter should be over 2mm, depends on the quantity of strips.